Build the SB square in one go
This lesson boosts: SB building
Lesson goal
The goal is to be able to build SB with “Build a square”.
Where this lesson fits
The next step after the basic steps. Just not inserting DR first cuts 2 moves on average (13.1 → 11.1). Combine it with “Use the M slice” for even fewer.
- Recommended once you're used to the basic steps
- No DR first: 2 moves fewer on average than the basic steps (11.1)
- You need to see how DR and the pair come together at once
| Basic steps | 13.1 moves | |
|---|---|---|
| Build a square | 11.1 moves | |
| Keep the square up, set up the next pair | 8.9 moves | |
| Use the M slice | 8.6 moves | |
| Break FB for optimal | 7.9 moves |
The step before this method. Start here if you haven't yet.
If you're interested in methods with fewer moves, check these out too.
Main content
Instead of inserting DR first, join DR with the corner and edge and insert them at once as a square. It works the same whether DR is on top or in a spot the right layer has turned away.
How to recognize
- Use this when DR isn't on the bottom yet: when DR is in the top layer, or in a spot the right layer has turned away (where R or R′ would insert it).
- Instead of inserting DR first, insert the easier pair first (front: DRF, FR; back: DBR, BR), or set up the pair.
- With the final R (R′, R2), insert DR and the remaining pair together to form the square.
Algorithm
- Don't insert DR first
- Look for how DR and the corner/edge (or pair) can come together
- With the last move, insert DR and the pair together to form the square
RU'M2U2r'U'R2RU'r'(10 moves)
- Don't put DR in first: bring DR and the back corner and edge together on the top
- Put DR and the back pair in at once, as a square (the front corner and edge became a pair on the top meanwhile)
- R U′ r′ puts the front pair in: done (10 moves)
DR on top: insert the back pair first, then DR and the front pair together as a square
UR'U'Rr'U'RUr(9 moves)
- Even if DR isn't in, insert the easier back pair first
- Insert the remaining DR and front pair together
DR turned away with the right layer: make the pair with the M slice, then turn the right layer back so it goes in with DR as a square
M'UMR'(4 moves)
- When DR is in the right layer turned with it, leave it there and make the pair on the top with the M slice
- Turn the right layer back: DR and the pair go in together, the square done